Tag Archives: aluminium

Endpin… again

Being fed up with the rattling and moving endpin on my honey Stagg I decided to fix it once and for all. The movement is due to three things: the long extending length of the pin, the cheap plastic the endpin plug is made of and the fit of the plug in the bass body. After some thinking on it I decided I had two options:

  1. change the whole assembly for a normal DB endpin en plug
  2. make a new, good fitting plug from a better material

As I had already put some effort in making a new rubber tip for the stock pin and did not want to spend a lot more money on the bass at this moment (the money paid for the new amp was still fresh in my memory…) I decided to have a go at option 2. I knew I had a piece of 35 mm diameter aluminum rod in the workshop somewhere and that would make a good starting point for a new plug.

The pictures below describe the process of making a new plug step by step. The new plug has been chemically blackened afterwards using Birchwood Casey Aluminium Black and the fixing screw has been threaded directly into the aluminum.

The plug has a tight fit in the bass body and is fixed by two countersunk screws that screw into the aluminium of the plug. I made the part of the plug that goes onside the bass body about 20 mm longer to give more support. The pin itself did not fit in the 10 mm hole I drilled… The “10 mm” pin actually turned out to be somewhat larger in diameter… So I had to ream this out a bit. But now it is a nice and tight sliding fit.

Below you find the pictures from raw material to the mounted plug. So far I can feel no play anymore and the rattle is gone too. Time will tell if this will stay that way.